please select HUIYUE transformer bushing auto through machine manufacturer.

Dongguan Hui Yue Technology HY-R20 automatically through the casing machine patented product, easy to operate, easy adjustment, the more Chen Hui-workers today to tell you about our automatic wear bushing machine requires only three simple steps can be debugged, its front-line staff can own operations, please read below, comes with photographs:

 

 (图三)  
The first step: the need to control: Press the "Start-up" button appear "SEEP" appears after OFF, turn passive feeding tube wheel (Fig A place), will cut a beveled teflon tube (Figure C at a ), adjusting the gap between compacts to twist loose behind the fixing screws (Figure B Office), and then adjust the preload seam rotating screw (Figure A) in, a third of the Teflon tube diameter to the size of the gap is too one-half to one standard, manually pulling the sleeve at Figure III A to smoothly without resistance, the sleeve can not be pulled out from the diagram III B double V mouth. Lock behind two fixing screws; (Figure II A with B)
                   
Step two: the control box at the Press "pressure pipe" - "cut pipe" - "pine pine-line" remove waste removal tube (Figure 3 A place). Check whether the fracture cut off sleeve Euparagonimus, if the cutting burrs or replace the nozzle cut flat pipe cutting blade, Open Graph III C two screws at the pipe cutting tool holder Figure III D set at removing It can replace the blade (blade white steel razor blades). After replacing the manual feed Teflon casing is installed, particular attention when in manual feed Figure 1 E Enter F point is when there is a collision, the collision detection if the corresponding collision position, you can fine-tune.
 
Step 3: Control the electrical box panel portion followed by "into the pipe," "pressure pipe" --- "pipe cutting tangent" - "and then open the delivery line driven wheel pull the thread on the tangent mouth straightened, followed by." - "clamp back line" ---- "shift to the line" ---- "clamp into the line" --- "loose tube loose line" --- "shift of control" --- "folder line back line "---" Exit "

 

Completion of the above steps, it successfully adjusted the Division I HY-R20 automatically through the casing machine, then we press the run button (green button) on the controller, so our HY-R20 automatic machine casing wear normal production use.

Related Technical Guidance: HY-R20 domestic first automatic machine two 0.1mm copper wire through the casing sleeve

Source：HUITUE transformer bushing auto through machine Manufacturers